I've been looking for a long time for an easy way to attach my Logitech C270 to my printer so that it can take the pictures for the time-lapse recordings directly from the front.
I also didn't want to have to remove the webcam's clamp base.
But either there were great mounts where I had to do exactly that and then screw it back on with an M3 screw or there were mounts that felt like 200g filament needed.
My goal with this holder was to get under 25g filament and a printing time of approx. 2h, which I almost did with a layer height of 0.2mm.
I also wanted to try to design everything in such a way that it doesn't have to be printed 10cm high, but can be easily assembled.
And it's printable with only a very little support on the round pin. Everything else can be printes without support.
Well, I succeeded and you can see the result here :-)