Another Kobra 3 Max filament run out sensor re locator. This one also has the ability to include a cable chain link to better control the cable from drooping and potentially touching a model during printing in which it get stuck to the model.
A short PTFE tube can be inserted onto the top hole to allow for the filament to not rub against the printed model.
Recommend using a high temp material such as PETG/ABS/ASA, since the printer maybe in an enclosure where temperatures may be high enough to warp PLA. I used ABS as it handles temperatures around 100 Degrees C which enclosed printers should not normally reach.

Sovol

SV06 Ace

Doesn't Matter

No

Seeing a need for not only a relocate of the sensor but also a need to add a potential cable chain link for better suitability of handling filament wastage and adds a potential for use of TPU as the PTFE tube could be omitted and thus reduces TPU problems from occuring.