This is a self designed peg board to hang stuff to the wall, like drones. Haven't designed any good "pegs" yet, the two included are just to show that it's working. The upper backside of the frame has a lip designed to go behind a wall screw or nail, to keep it from slipping off. Included are printable M7 screws, so you can screw more panels together. The panels have rectangular holes, so you can fiddle LED-tape through to make it backlit. (something I haven't tried yet, but should work).

Material pretty much does not matter, I used cork filament, because I had no other use for it. PLA should just be fine. Screws should be printed in harder material such as tough PLA or ABS with at least 50% inflil, else they will crack whilst screwing in.

Creality

Ender 5

No

No

0.2