RMS Queen Mary 2 is a British transatlantic ocean liner. She has served as the flagship of Cunard Line since succeeding Queen Elizabeth 2 in 2004. As of 2017, Queen Mary 2 was the only ocean liner still in service.

This model is also available on our cults3d page.

This model is not 100% accurate and is designed to print at 1/300 scale but has not been printed at this scale so we cannot guarantee that it will print with no problems.

Please note that even though this model does print at 1/600 scale there are some imperfections to the finished prints.

We would love to hear any feedback you have as this helps us provide better models and don’t forget to share you prints and build photos with us, we love to see them.

If you experience any problems with the files or printing process please get in touch and we will endeavour to resolve any issues in a timely manner.

Email - iconic3dmodels@gmail.com / 3dprintoutz4u@gmail.com

Anycubic

All-metal Mega

No

Yes

20

these setting are based on 1/600 scale print

Filament - PLA

Nozzle size - 0.4mm

layer height - 0.2mm

Print temperature - 180c

Print speed - 40mm/s

Layer settings - Top - 6 / Bottom - 6 / Wall - 4

infill - 10-20%

Supports - Manual placement of required supports is highly recommended.

• minimal supports are required on part 1.
• supports required on parts 3 and 4.
• No supports are needed on part 2.

Print time - Part 1 - 19-23 hours / Part 2 - 21-24 hours / Part 3 - 17-20 hours / Part 4 - 20-23 hours

Filament required - 280 meters

difficulty rating - medium. prints well but lots of tricky supports to remove on parts 3 and 4.

Model dimensions - Length - 566mm / Width - 87mm / Height - 120mm

Notes - scaling this model down any further then 100% will likely cause printing errors and is not recommended.