4-sided hood for the 5" SmallHD Focus (micro HDMI LCD, no experience with OLED or SDI variants so check before you print). Took a few iterations to get it strong enough not to snap the clips when removing, it's good to go now but since I'm still nervous: REMOVAL NOTE [pull directly away from the monitor when removing, start with the arm-side so it doesn't lever against it and stress the edge]

I wanted 4 sides and it's shallow enough to still operate the touchscreen. I couldn't think of a good way to make it 3-sided like the OEM one and have it print without supports, so you've got the .SLDPRT if that's something you're interested in.

Creality

Ender 3 Pro

No

No

.2

Like 10 perimeters to max it

Print with the semi-circle cutouts up and the part you'd look into against the bed (as in screenshot). Doesn't need supports or anything, but you might benefit from a brim depending on how well your stick is.

Don't bother with infill, just go ahead and crank perimeters up to 10 or something similar so that it prints the whole thing that way (the areas that would qualify for support with a 3-wall print are such a minuscule amount of material, better to just up the strength, especially around the clips).