This is a remix of two separate sunflower models. The main contributions are a modification of the stem (made two halves one whole to avoid gluing; extended to add length and allow for insertion into pot) and the design of a pot into which the sunflower can be inserted. In order to attach the flower to the stem a hole must be drilled. This allows for mounting at the angle of your choice. For those that don't have a multi-material printer, the heart and flower can be printed separately. After printing, align the heart inside the flower and tap it with a hammer until it seats properly.

Prusa

i3 MK3

No

Yes

15%

Printed in PLA with the following layer heights:rnrnHeart - 0.15 mmrnFlower - 0.2 mmrnStem - 0.15 mmrnPot - 0.3 mmrnrnStem requires support. No supports needed for the flower. The pot can be printed without supports but the overhang will be a bit messy. Working on a version with a chamfer instead of a straight ledge to make for cleaner printing without support.