This is a pair of light bars for the Ender 3. I noticed all of the light fixtures for the ender 3 on this site had obstructions in the way or were an obstruction for fan mounts. This setup lights from the bottom and sides so you can always see your print no matter where the tray or head is, and you can still use your fan mounts. I used 5630 white LEDs and ran them in series to the 24 volt power supply. you can mirror the bottom section in your slicer to get the left side. In order to prevent supports, I printed this off in 2 sections and super glued them together. If you want the full uncut version, let me know and I will upload that file as well.

UPDATE 4/14/2019: Per request, I added some clips due to the adhesive on the LED strips not adhering well. I print them with the extra fine setting due to the small size. It takes about 5 minutes to print it on mine like that. When printed correctly, they will snap in place and stay there due to friction.

Ender 3

No

No

fine

20% +

This is a pair of light bars for the Ender 3. I used 5630 white LEDs and ran them in series to the 24 volt power supply.

You can run in series to the 24v power supply or there is a 12v power source on the board that you can run in parallel, but i am not sure how much wattage can be added to it, so to be safe, I just ran it to the direct 24v line in series.