I really had a hard time finding something decent to wall mount my Pico 4 headset and controllers, so I decided to design my own.

2 factors I chose when designing it:

1. Minimal Filament
2. NO SUPPORTS

So, this design comes in 3 pieces. The wall mount with headset rest and then 2 separate controller holders, which print standalone (no supports) and they slide right into the wall mount (I used and old Ender design I did for the rails, functions exactly the same).

The controller holders slide in nicely, but to make them permanent, you might want to pop in a small droplet of Krazy Glue to keep them in place forever, otherwise they might slide out when removing your controllers.

Under the headset rest are 2 posts in case you want to wrap your charging cord or whatever.

I made 2 versions:

• One does not have holes
• One has Screw Holes - (I recommend this version, because if double-stick tape fails,
  that's a pretty expensive break! potentially

Hope this helps some of you out... I absolutely love it!

Cheers!

Bambulabs

Bambu P1P

No

No

.20

20%