A simple two-part "exoskeleton" for the Raspberry Pi, including the SD card area.

Print at 10% infill or even lower to use even less filament!

You will need:

3x M3x30 cap head screws
OR
3x M3x35 countersunk socket screws
3x M3 nuts

The holes for the screw heads and nut traps have printing supports. You can easily remove them by putting a screw in the hole and tapping it until the support breaks, or run a 3mm drill bit through the hole.

I made this mostly to learn OpenSCAD.

Print at 10% infill or even lower to use less filament!

You'll need:
3x M3x30 cap head screws
OR
3x M3x35 countersunk socket screws
3x M3 nuts

The holes for the screw heads and nut traps have printing supports. You can easily remove them by putting a screw in the hole and tapping it until the support breaks, or run a 3mm drill bit through the hole.