Thank you Ilnaij for your excellent design!

This is an electronics case for BigTreeTech's board BTT E3 RRF + BTT IDEX Module that fits the standard Ender 3 and Ender 3 Pro.
I couldn't find a proper solution for mounting the IDEX module so I took the time to come up with my solution.

I took Ilnaij's excellent case for the E3P and remixed it with a few major changes:

• Both the BTT E3 RRF board and the BTT IDEX Module fit inside a single case.
• The case fits the standard Ender 3 and Pro version (did not test the Pro version).
• All the holes for the headset inserts are corrected for the type of inserts I have on hand (M3xD5xL4 inserts).

Update 03/09/2021:
~Added the Ender 3 Pro version
~fixed some alignment issues

Creality

Ender 3

No

Yes

200

35

Wall count - 3
should only need support under the center beam but everywhere is ok too