Original Design Wizard of Oz Scarecrow - 2X (Double Size)

Everything prints in the orientation of the models.
Might want to use a brim to be safe.

I printed at .12mm using Cura for slicing
Thin Walls should be on (enabled)

For Legs Start with Black Filament,
Switch to Straw at layer 55
Switch to Brown at layer 65

For Shirt (Torso), Straw sticking out of shirt should be cut with nippers close to extra support (don't allow additional supports in straw area).
Next use a hair dryer to shape straw.
Paint straw with acrylic paint after shaping.

Use acrylic paints to add color to areas of models as desired.

Depending on how well your printer prints, the head might be a little loose,
If it is, just put a bit of masking tape around the inside of the neck and that should do it.
Also recommend putting a thin strip of masking tape on posts of each of the arms and legs to allow for better posing.

Creality

CR-10S

No

Yes

.12 mm

20% or less