This is a simple bracket to modify your ET4 in a direct drive, you will need to provide longer cables for the motor and filament sensor. It is inspired by this design https://www.thingiverse.com/thing:4356608 , however I redid everything from scratch.

Labist ET4

No

No

0.4

50%

You will need longer cables for the motor and filament sensor , be sure the motor rotates the right way , if not you may have to swap cable 1 and 4 on the motor 6 pin connector. BEWARE getting the connection wrong WILL fry your system board. See the picture I included !. You will have to connect the hotend with a length of pfte tube and pneumatic connectors.

Created with FreeCad