This strawberry planter has been created for an Instructable. Great as a summertime gardening project to try create more playful planters. This planter is inspired by the strawberry and reflects it in its form in a functional way.

Prusa

i3 MK2S

Doesn't Matter

Yes

.3 or lower

20%

I used Cura and imported the Official Prusa settings from their website and it work brilliantly first time. I use .3mm just because its the biggest i can go with my nozzle but i'm sure this can work at smaller resolution. Larger resolution will use seed detailing.

There is no tolerance between the bottom legs and the planter pot. You might need to sand or file a 1.5 mm indent into the bottom legs so the pot sits snugly on top.

The planter has to have a gap so that there is airflow going through the holes at the bottom and so water can leave when over watered. KEEP THIS IN MIND!

You may want to finish this model by adding some paint to create a more colorful strawberryful result. In that case sand the parts with different grades until a smooth surface appears and fill and seal and cracks on outer surface.

With an airbrush or spray can spray the primary base color like red and then with a fine brush paint the dark yellow seeds.