Summary

It is adjustable pasta cutter. It can make different size of noodle or pasta, and only change you need to do is changing the spacer size.

I printed mine at 0.1mm resolution, 80% filling, 3 layers wall/bottom/top, G-code was generated by Cura Engine. Tested, works well enough.

It includes

1. blade: 1mm thick blade, with reinforcement in the middle.
2. two pieces of shaft : I need 10cm shaft, however not sure about the print will stick to bed well enough for a tall and skinny part, I decided to cut to half length to 5cm each.
3. handle: basically hollow inside with beam support inside.
4. handle cap: fit at the end of handle to close the hollow.
   5 spacer: I had the choice to combine blade and spacer. However, I may want different thickness of my noodle. With spacer, I only need to print another set of spacer, instead of changing all the blades.

Enjoy it~!