This is a camera mount for an autel evo. It's designed to hang below the drone.
Its made to work with this mavic camera mount's camera support hardware.

https://www.thingiverse.com/thing:4257872

it's held on with a Velcro strap to go up and over the battery to hold it on. zip ties could be used but you'd probably have to cut them off when done. it's mainly for holding a 360 degree camera. allowing it to "hang down" below the drone. (it helps to disable the sensors.)+

Creality

Ender 3 Pro

Doesn't Matter

1.6mm

100

I printed with 100% infill but you can experiement
might be able to print without generating supports but I printed with them touching buildplate