Bit holder for the spare belt hook screw ion your drill/driver. Holds 5 standard bits using the power of magnets!

Once printed simply press in the magnets, they are snug so may need a good shove.

This is to fit the right side of a driver, for the left simply mirror before slicing.

You will need:
5x 5mm diameter x 2mm tall Neodymium magnets.
1x mount screw.

For my Makita I used an M4x20 which is a shade long, 18mm would be better but you'll need to cut one down.

For Dewalt I believe they use M3 but check on your own tool.