Slugy is the LazySlug mascot — and a print test that isn't boring.

The sole is cut dead flat, so the entire first layer is the full contour of

the foot and everything above it leans inward. **No supports, no raft, no

brim.** If Slugy comes out clean, your first layer, your overhangs and your

small-part cooling are all in good shape. The eye stalks are the hard bit:

thin, tall and tipped with a ball. That's on purpose — it's the part that

tells you whether your cooling and travel settings are honest.

## Specs

- 50 × 26 × 42 mm as designed — scales freely, there are no fragile thin walls

- ~12 g of PLA at 15% infill

- 0.2 mm layers, no supports

There's a small lazyslug.hu engraved under the sole. That's us — a small

3D printing shop in Hungary. Print it, remix it, post a make: that's all

we're after.

---

Magyarul: a Slugy a LazySlug kabalája, és egyben egy nem unalmas

tesztnyomtatás. A talpa laposra van vágva, így az első réteg a teljes

talp-kontúr, fölötte minden befelé dől — alátámasztás nélkül nyomtatható.

Ha nincs nyomtatód, mi kinyomtatjuk: lazyslug.hu