This project is mostly for my enjoyment, any feedback is greatly appreciated, especially with the print configuration since I mostly created the model and commissioned someone else to print it, I have 0 other 3D printing knowledge.

A dummy model meant for decoration on model guns. The lens caps are flippable. You should be able to mount it on any Aimpoint T1/T2 pattern mounts.

Hardware needed if you intend to use this on a compatible mount (Use one of the 3 below):

• 4 M3x5/6mm screws to attach it to a compatible mount, or:
• Aimpoint T1/T2 compatible screws (real/airsoft), or:
• Superglue, if you don't intend to get the sight off the mount.

Some printers might struggle to print the cylindrical pins for the lens caps, in which case you can use whatever fits the length and diameter e.g. piece of filament wrapped in tape.