This is a remix of Joe Barnard's BPS Rocket Cradle that adds interconnecting braces to maintain spacing between multiple cradles. The braces connect to the cradles using dovetail joints. Two different lengths of braces are included: 150mm and 300mm, which support most printer bed sizes and allow for finer adjustment of brace length. Also included are couplers that allow multiple braces to be connected together to get custom lengths.

The Vs and Extensions from the original Thing work with this remix.

Print Settings

Printer Brand:

Snapmaker

Printer:

Rafts:

No

Supports:

Resolution:

0.2mm layers

Infill:

Filament: Elegoo Rapid PLA+

Notes:

Post-Printing =============

The brims must be trimmed off each brace. Initial fit of the brace into the cradle will be tight but will loosen up a bit after the brace is inserted and removed.

Category: DIY