Instructions

Print without supports, assemble without glue:

1. Print 1 stud (parametric_snap_base_Base.stl) and 1 crocfinity base (crocfinity-gridbase.stl):

   • I recommend 3 walls for the stud

2. Place the stud through a hole in your Crocs with the crown sticking out the top

3. Snap the crocfinity base on

4. Place any 1x1 gridfinity tray of your choice on tray

5. Repeat for other foot

If you're going to be walking around with your gridfinity trays on your clogs, I recommend populating the magnet pockets in each corner (they fit 6x2 mm magnets)

Fine print

The Gridfinity base plate is based on the one generated by https://gridfinitygenerator.com 

The Gridfinity system itself is licensed under the MIT License and you can read all about it at https://gridfinity.xyz/