This description is available in French and English.

Conception

The closet shock absorber trigger is designed forThe sliding wardrobe doors, it's this part that takes all the impact when we close our doors, and sometimes this part breaks. That's why I designed this model.

This trigger is used to slow down the closing of sliding doors, thus preventing sudden closures and extending the lifespan of the cabinet.

Printing tips

Use PLA or ABS filament for its robustness. A fine layer resolution is recommended to ensure a good fit. It is advisable to perform a post-processing to remove any residual printing debris.

Assembly instructions

Make sure the trigger is firmly fixed. It should be, heat it a bit so that it fits in and holds well, because I deliberately made it a bit smaller to heat it.

-----------------------------------------------------------------------------------------------------------------------------------------------------

in English :

Design

The closet cushioning release is designed for sliding closet doors. It's this part that takes all the impacts when we close our doors, and sometimes this part breaks, which is why I designed this model.

This trigger is used to slow down the closing of sliding doors, thus avoiding abrupt closures and prolonging the life of the cabinet.

Printing tips

Use PLA or ABS filament for its robustness. A fine layer resolution is recommended to ensure a good fit. Post-treatment is recommended to remove any residual print debris.

Assembly instructions

Make sure the shutter release is firmly attached. It should be, so heat it up a bit to make it fit, as I deliberately made it a bit smaller to heat it up.