Bathroom storage cup with removable dividers and removable bottom tray for catching water. Holes in the bottom of cup allow for water from toothbrushes to drain into the bottom tray. The two walls are removable and can be configured to be halved, quartered, or no insert at all. 

Printer setting: 

Filament pictured is Overture Rock White PLA 

Infill - 10% 

Nozzle Temp - 210C

Bed Temp - 60C

Support - Cup only, this supports the overhanging ripple on the outside. I set angle threshold to 80deg to avoid support being added to inside grove for dividers. 

Layer Heigh - 0.2mm

Assembly - The divider walls slide together then slide into the cup. I recommend using some light sandpaper on the contacting edges to allow them to slide into place easier. The cup does not attach to the base, it simply sets on top of it.