So I had some old logitech speakers and needed stands for them.

I print these with supports but avoid painting them into the screw threads if your slicer lets you as it makes removing the support difficult and can foul the thread.

I print a base, 4 verticals then add a the ring before screwing the top on, the cable management on the ring isn't great but its main job is to offset the thread so the top and base line up to face the same way. Its a bit of a bodge but the top, when screwed tight, tended to end up at a right angle to the base.

There might be better speaker stands out there but these work for me so sharing for anyone who wants to give them a go :)