This is an ATX-compatible I/O shield for the Monotech NuXT v1.2 board.

It mainly serves to not look ugly when you mount a NuXT in a MicroATX case.

If you want to build your own NuXT and solder it together, PCBWay has a board ready to go for you; mine was ordered from JLCPCB.

If you want a NuXT with considerably less hassle, Monotech will sell you one and you won't need to print my shieldzilla here.

You'll want to figure out a way to mount to the case properly; I wasn't able to get a friction-fit quite right, so I used double-sided tape (not mounting tape!)

Creality

Ender-3 V3 SE

Doesn't Matter

No

0.12mm

100%

Initial print was done with PLASilk, but PLA+ works just as well; and if you scale for ABS (101.3% on my printer) you'll get a fine result.

This part was designed in Inventor from mechanical measurements taken of several mATX cases, several ATX I/O shields, and measurement of the NuXT board itself.