Christmas tree stand adapter

This is a replacement / reinforcement stand for a fake Christmas tree whose original plastic base legs fell off (as they usually do right before December).

The original tree base had a hexagonal shape, but with alternating edge lengths:

• Long sides: 24.15 mm
• Short sides: 17.85 mm

This stand is designed to "encapsulate" (wrap around / fit over) the existing base — without needing to modify the tree stump — one can reuse the original mounting point just as it was. The distance between opposite legs is approximately 250 mm.

Printing parameters

• Material: PLA (works perfectly fine for indoor use)
• Infill: ~10%
• Supports: required (to maintain three-point stability - if you are sure your ground is flat - go ahead and make the base flat)
• Orientation: print upright
• Layer height: 0.24 mm
• Perimeters: 2-3