axle v1:

Small part (32 minutes, 6g, 2.04m) to test the radial gap between parts as 0.5 mm
(print without support and adhesion by standard [fine - 0.2mm] settings)

1) but set the Wall Ordering - Outside To Inside
2) but set the Z Seam Alignment - Shortest

Result: The axle dangles quite freely after being removed from the table.

axle v2:

same part as v1, but with radial gap 0.3 mm.

Result: The axle almost not dangles after being removed from the table.

<<< we are here >>>