This is a mount for the TFT screen on the Qidi Tech X-One to allow you to put the screen on the side of the machine for a narrow profile area and to make the screen higher up on the machine and angled. I also included a faceplate from the front so you can cover that hole up.

It requires 4x 12mm M3 Screws and nuts to hold the faceplate onto the frame and a strong magnet to hold it flush to the frame (I used a 1/4x3-1/4" neodymium magnet I had on hand). You will also need a much longer cable to connect to the board under the frame. I found a Pitch 1.0mm 40-Pin FFC/FPC Flexible Flat Cable on eBay from China for about $10 after shipping. You need the Reverse Direction kind.

This is a remix from thing https://www.thingiverse.com/thing:2390608

QidiTech X-One

No

Yes

0.2

20%