If you have ever tried to change the microSD card in the Raspberry Pi when it is mounted on something (touchscreen display in the pictures above), you will know it is very difficult because the card is on the back of the board and only sticks out a couple of mm.

This is a simple tool with a slot that goes over the end of the microSD card in the Raspberry Pi, and can remove and install the card easily.

To remove - place the slot over the exposed part of the card, lean the tool slightly to grip the card, then pull back to remove the card.

To install, insert the card into the slot, and then hold the tool at an angle to the microSD card slot, and insert one corner near the center of the Pi board. You can feel the socket, and slide slightly until you feel the edge of the socket - then you can push the card straight in. To keep from accidentally removing the microSD, twist the tool to get the microSD out of the slot. Then push the microSD card fully in place with the side of the tool.

Creality

CR-10

No

No

0.2

30%