This is a replacement of the Playmobil rocket 6187. You can print it with PLA, but it is a little bit hard if it hits something. Better print with TPU or other flex materials. The thickness of the shell is 0.8 mm, so with a 0.4 mm Nozzle this will be 2 shells. Try to set the extruder factor to more than 100% for better layer fusion. Supports are not needed due to the inner structure which is not a sphere at the top. Rafts may be used but were not neccessary with my printer.

Renkforce RF100 v2

No

No

0.2

30%-100%