A simple door stopper model

As I live in a oldish house, I looked at my door stoppers and notices that they need to be changed. And currently I am without a mode of transport, I drew this model in OnShape of course inspired by the old door stopper.

I have printed these model in PLA, but there should not be any reason it could not be printed in other types of filament.

The STEP files should be under files, so it is easier for modifications.

Mounting guidelines

1. Screw the mount to the wall

2. Slide the shell over

Mounting in colour pictures
Photo 1: The original door stopper from cirka 1973
Photo 2: The original door stopper mount
Photo 3: The new mount installed
Photo 4: The new shell in progress of install
Photo 5: The new shell installed

In the CAD program I made the hole 5mm in diameter, if you get a small amount of engagement from the screw it should be fine otherwise I have provide the STEP files. Make the change and remix my model :)

Print guidelines

Mostly you should make do with the default print settings on your printer. 

PLA infill: 25% should make it last longer