Summary

a controller case for 10 Nintendo Switch games.
optionally with logo or without.
the support is only required for the housing and only a little.
If the pads are difficult to push in, just go over them lightly with sandpaper.
The cover with the logo should be fixed with glue.
I printed it out on my AnyCubic I3 Mega.
If something is wrong with the model, write to me.
Have fun building and playing.

PLA print
nozzle 0.2 mm
15% volume
print speed 50 mm/s
support needed
dimension complett
X=63 mm Y=100 mm Z=14 mm