small table supported by cables in tension, it is about 10cm x 10cm, I also set the holes so that the knots of the fishing line can be hidden inside (they are about 2.5mm deep) and I also set a small 8mm chamfer and 1mm deep for small rubber feet. I also upload the .f3d file so that if you have different feet or if there is a need to change the size of the holes the source files are available.

if you want, I recommend the supports exclude them on the pole so that they are fewer and simpler and the printing times are greatly reduced (as in the screenshot).

the 2 pieces are perfectly mirrored so it is sufficient to print the piece twice, there is no top and bottom.

ELEGOO

ELEGOO NEPTUNE 4

No

Yes

0.2

10-15%

PLA