As i needet this to fit on a bigger table i changed the distance between the clips to 6cm (2,3622 inch).

And in addition to that i also modified the stick and knob so that i can light it up a bit.

i used a WS2812b digital LED which lights up green and when a button is pushed it blinkes red.

Also if not used for a while it will go through a rainbow routine.

The wires for the LED run through the stick.

Use a transparrent filament for the knobV2_top (i used 5% infill)

Only thinges needed in addition to the original:

• 3 x M3x30 Bolts
• 3 x M3 Nuts
• 1 x M8x50 Bolt
• 1 x Digital LED
• some wires
• and if you want to diable the LED a switch. Just drilll a hole if you need.

Libraries needed for the code to run: Joystick and FastLED

If you dont need the led use GetShifty-WO-LED.ino

Print Settings

Printer:

Felix Tec 4

Rafts:

Supports:

Yes

Resolution:

Infill:

35

Category: Video Games