This is a case for the FriendlyElec Zero Pi

Connect the top and the bottom with four M2.5 screws.

The case leaves room for a heat sink on the CPU and I strongly recommend installing one.

Made with TinkerCad: https://www.tinkercad.com/things/fiVW2oiEQQf

You’ll want a couple of perimeters around the screw holes for strength. Other than that, it’s dealer’s choice. I went with thin walls on the top to show off the translucent filament and let the LEDs blink through The print in the photo is made with Protopasta Opaque Black HTPLA on the bottom with ProtoPasta “Annie’s Blood Of My Enemies” HTPLA for the tops.