Here's my version of a mouting / rack system for various Ubiquiti gear. There are quite a few here on Thingiverse, but nothing that directly suited my needs, so I set out to make my own using Tinkercad. This system allows stacking of networking components on top of each other but provides space between for air circulation and neat routing of ethernet cables. Each section is held together by a pin. I originally had these incorporated into the design but found that the pins on my initial prototypes broke off when assembling, so it was easier to make these separate so they could be printed with higher infill percentages and/or replaced if they broke. Everything should print without supports. I put these on a slight diagonal to ensure they would fit on my printer bed.

Quidi X-Plus

No

No

0.2

15%