Over 2 years past initial covid shutdowns, work finally bought me a webcam! Well, got me a used webcam. Now, like the other hip kids these days, I need a webcam cover to ensure my privacy.

It's a quick and simple print. 0.28 layer height worked great for me, printing both pieces in under 20 minutes, only using 1.9g / 0.63m of filament.

The circular opening is 15mm, so please check your lens diameter to make sure it's large enough. 

The base is 49mm wide x 27mm tall.

The hole for the LED indicator is 16mm from the center of the lens. There's a separate base file without the hole. Need a different location for the LED light? Let me know and I'll nudge the hole over wherever you want.

Remix

This is technically a remix of Reven's webcam cover, but other than the gripped slider I ended up designing this from scratch. It was a good basis for inspiration though! I just needed something larger to suit my needs, and fiddling with resizing their original design didn't quite work out.

Installation

I used thin double sided tape to adhere mine to my webcam. Glue would work as well. Take your time to get it centered well. 

Enjoy!