Topping E30 and L30 stack shelf holder
CoastalWhale
Trouver des similitudes avec l'IA
Profil d’impression(0)
Fichier modèle(0)
0
0
0
Publié:2026-01-14 18:30:55
0
0
000Description
Tags
Source du modèle
Avis(0)
A little shelf in which you can put your topping stack. It prevents the top one from sliding around on the bottom one and getting misaligned.
The top unit is secured pretty good since its feet fit nicely into the holes, however, the bottom unit can still slide forward and backward.
Print Settings
Printer Brand:
Anycubic
Rafts:
Doesn't Matter
Yes
Infill:
100%
Filament:
Sunlu PLA Black
Notes:
I printed this on an Anycubic i3 Mega with some cheap PLA, but you can use anything else as this model doesn't have a lot of detail.
I had to enable supports otherwise the holes would come out looking pretty bad, however, you may not need them.
Tags
Source du modèle
Lien original: Voir les détails
CC-BY