Hello Friends,

This project has been developed for overcoming the print problems in your 3d printers arises from the moisture of the filaments.

With the 100 w heater in the project and relays that keep this heater at 40 degrees for 4 hours, the moisture problem of your filaments will be goes away.

Moreover, with the filament spool in the box, you can load your filaments directly in your 3d printer.

You need to place silica gel in the box to get the moisture that has been removed from the filament thanks to the hot air produced in the box.

Other materials used:

1PCS W1209 DC 12V heat cool temp thermostat temperature control switch https://www.aliexpress.com/item/4000046672924.html

1PCS DC5-36V Dual MOS LED Digital Time Delay Relay https://www.aliexpress.com/item/4001162488240.html

1PCS Temperature And Humidity Sensor https://www.aliexpress.com/item/1005002363224519.html

1PCS 12V 10A Power Supply Slim https://www.aliexpress.com/item/33004205689.html

1 PCS 12V 0.17A Cooling Fan https://www.aliexpress.com/item/4000732209034.html

3PCS Thermal Insulation Aluminum Plate 30x50 cm https://www.aliexpress.com/item/1005002310716677.html

4PCS 608zz Bearing https://www.aliexpress.com/item/1005001880737929.html

Nichrome Wire https://www.aliexpress.com/item/4000860860923.html

Silica Gel https://www.aliexpress.com/item/32772734661.html

Fiberglass Tube https://www.aliexpress.com/item/33048291763.html

22AWG Electric Wire https://www.aliexpress.com/item/33030229363.html

1PCS 25x25x30cm Storage Cointainer