Summary

This is a power connection panel to the Anycubic linear plus.

The original power cables are screwed onto the controller board which is very inconvenient. I converted the whole thing to XT60 connectors as I am used to them with drones.

You will need 3* M3 screws and nuts to hold the XT60 connectors in place.

To mount the panel to the printer, I used another 4* M3 screw and nut sets, as I ran out of the original screws in the kit. The M3 screw back plates are only needed if you go for this DIY solution.

You may want to check out the other design of mine which gives 2 XT60 connector on the power supply.