mikroY4

After the success of drunK131 I wanted to challange myself to follow the line of one part print style and create even smaller racing quadcopter.

In my 3D printedquadcopters fleet that I have designed you can find a Tricopter, Racing quadcopter and Tiny Whoops. This time I was looking for something new a 16*16 Flight controller size micro Y4.

The idea behind mikroY4 is to create one part printed Y4 frame, mainting one part print add durabilty to the 3D printed frame.

Printing the frame

This is my first attempt to print Nylon, I'm using ePA from Esun and printing at 215°c on my Tevo Tarntula stock was smooth and without any problem.

Instructions

• 1. Print Main_Frame and Upper_back_tail_motor_mount
• 2. Add your electronics, check my part suggestions below for my built
• 2a. First I mount all the motors and place the motor wirings through their holes
• 2b. Then I place the 4in1 Esc's with the FC stack, receiver and AIO camera. Dont forget to pre solder everything!
• 2c. Solder the motor wires to the 4in1 Esc's
• 3. Load Y4 configuration in your favorite FW, Im using BetaFlight

Part list

• 16*16mm F4 Flight controller and 4in1 Esc's STACK
• AIO cam
• FrSky compatible receiver
• 4 1102 11500Kv brushless motors
• 2" props set
• JST connector
• 1M screws for plastic
• 2S 350mah Lipo battery

Recommended Tools I used:

• Highly recommended Soldering station .

• Free Hands.

• Cable cutter.

• I own two printers CR-10 and Tevo Tarntula

• Multi tool

• I always like to check my connections with a Multimeter

• Hot glue gun

• My phone Meizu Pro 6 Plus

You have to clean the supports