Summary

Filling Module cap for small ports
The standard filling module has 3 small ports that tended to leak on my tower. This plug fits over the empty ports to stop this leak.

Printed in PETG as PLA likely to distort due to constant pressure on the 'legs' that fit into the port.

Pots 90 percent
I've taken an original 3way and 4/5 way and reduced the 'wet' end to 90% of its original diameter which makes removing/inserting the pots easier.

40mm Break/Distributor
I found that for my tower that is 8 (hollow) modules high the water velocity increased as it fell over the length of the tower eroding the peat/perlite mix that I was using in the pots. I've taken the water distributor and remixed to provide a similar base to the standard module but with slightly larger holes and with the base sloping towards the outer wall.