A 1/8 turn mount insert for a Beeline Velo 2, that replaces a garmin quarter-turn style mount insert. Designed for mounts with a 22mm spacing between the mounting bolt holes, such as the TOWILD ALB05 handlebar mount.

Printed using PETG and tested successfully on my own bike. Came up with this because the official insert adaptor that beeline sells doesn't have a wide enough hole spacing for some mounts - such as the TOWILD one mentioned above.

Because the screw holes are so close to the edge, it is a little bit of a squeeze to get the screw heads past the locking tabs on the rim, but it can be done. I recommend getting the screws into the holes before trying to line it up with the mount bracket.

Print settings (used on a Creality Ender 3 v2):

• PETG filament
• Layer height: 0.12mm
• Infill density: 100%
• Supports: partial - only underneath the central section, not under the 4 corner tabs round the inside edge of the rim.