Print instructions

I modified the design so it would fit this specific clock mechanism. I scaled it up to about 25cm, so the clock is a nice addition to to your room without looking small. 

It printed fairly easily on my Bambulab A1 however, I definitely needed the brims for the hour and minute prints to get good bed adhesion.

I decided to print with fuzzy skin, and used the paint fuzzy skin tool. I also decided to print with very thin layer lines. This made the quality look good, however, printing will take a while. 

Make sure to let the bed cool down before removing everything so all the squares stay square. 

Post-Printing

Assemble in this order:

• Screw the movement on to the flat face
• Press the hour hand on
• Press the minute hand on
• Add the metal cap over the shaft, if your movement has one
• Snap the flat face into the frame