Do you live in an apartment where you can't easily change the plumbing? Did you recently buy a shower head that shoots the water straight at your wall because its angled too high? Are you making a mess?

Well then, you are me right before I got my first printer! After tinkering a bit with a very basic custom design, I came up with something that works as shown in the picture. There's a tiny arm attached so you can hang your loofah and everything!

This is my first custom model and its very specific but the angle works out perfectly for me where it lands just before the end of the tub/back wall. For my prototyping I used the very popular shower head on Amazon called “AquaCare High Pressure 8-Mode Handheld Shower Head”. 

I used PETG-HF as the material for added durability. You don't need to go transparent, I did because its my first roll of PETG. Also all my profiles all slowed down to reduce noise since I live in an apartment, so feel free to speed things up if you want but do be careful as this took many attempts to get right temp and speed wise due to the nature of PETG adhesion.

Thanks