Cool little corner desk based off of the current desk i have in my room. Very simplistic and fun.

5 parts in total

The desk its self is a 25% infill, you can change it if you would like, doesn't matter. and was printed at .1mm layer height

There are two types of drawers, the "desk d 2" is the drawer that goes on the bottom, only print one of those, the "desk drawer" are the top 3 drawers, you will need 3 of those. Infill again was at 25% but doesn't matter. and again with a .1mm layer height.

Oh and remember to print with support!