Printing

Defaults settings with no supports worked for me, using PETG. I set the bed plate in the fridge after printing to ensure the part cools completely before removing, else it can break. Should snap into place as a battery cover panel replacement, but may require trimming the notches a bit if the filament oozed over too much.  

It's much better than a piece of tape, I'm so sick of taped up remotes, hopefully this can help at least one other person, then all of this becomes worth it.

I've included a STEP file in case anyone wants to make tweaks, please add them as remixes to this project if you do. Happy Gaming!

Credits

Designed in Autodesk Fusion 360 CAD software with the free hobbyist license (2605.1.52 Build)

Sliced in Bambu Studio ver 2.4.0.70

Printed in Translucent Red OVERTURE PETG 1.75mm filament on my BambuLabs A1 with AMS lite

To my four cats, thank you for supurrvising while I worked