Introduction

I've been having this extra Audigy Drive lying around with its internals exposed. So here is a PlayStation 2 themed shell to encase this thing for easier handling and storage.

Printing

Print the pieces with the default orientation. Supports are required for all 3 pieces.

Assembly

This case requires 4x M3x6mm screws to install. Do NOT over-tighten the screws, or you risk cracking the walls.

Lay the back panel onto the back of the drive, then drop them into the bottom case. Then put the top shell over and put on the screws.

Misc

You can use an ordinary IDE cable with the Audigy Drive. Just make sure Pin 1 is oriented correctly as indicated.