It's become difficult to find panel-mount SCART sockets, so I made this bracket/spacer that converts a common generic PCB-mount socket to a panel-mount one. This allows you to mount the socket flush and secure against the back panel of a monitor or other device.

Required hardware:

• Vertical PCB-mount SCART socket with M2.5 screw holes
• 2x M2.5 x 20mm screws. In some cases you may need to go up to 25mm
• 2x M2.5 nuts

Several variants are provided for different panel thicknesses.

Note: The model should be printed with the flat side down. For laziness-related reasons it probably won't be oriented that way when you import it into your slicer. Make sure to flip it over if you need to.

The examples in the photos were printed in Bambu PLA Basic (Pumpkin Orange and Bambu Green).

Links:

• Suitable SCART socket on Amazon
• Suitable SCART socket on AliExpress
• M2.5 screw kit on Amazon

Change history:

• v13 – 2025-07-18 – Initial release.