Custom wireless charging phone stand

This charger needs some electronics, you can buy this from Ali Express:

Qi Wireless Charger PCBA Circuit Board

And you need to do some soldering. See images for visual instructions.

You can make the stand custom made for you phone. Measure the width and height of you phone, including the phone case. Then, open the Customizer and enter the width and height in millimeters and click the Create Thing button.

Print the lid with transparent filament, if you have that.

Print Settings

Rafts:

No

Supports: 

No

Post-Printing

Required:

• Wire
• Qi Wireless Charger PCBA Circuit Board
• Soldering iron and solder
• Heat shrink tubing or other insulation material like adhesive tape
• Glue suitable for plastic

Cut and strip two wires of about 42mm (1.6 inch) long.

Solder the wires between the coil and the green PCB.

Add glue on the coil and glue it to the stand. Be carefull when applying pressuree: the grey disk is fragile and can break easily. But it will still function with a crack.

Insert the PCB with the USB-connector first.

Use a screwdriver or something similar to press the wires in the slit.

Insert the lid.

Category: Mobile Phone