Set of stands for use with small stickless arcade controllers such as the Open_Core0, Open_Core0 WASD, the Flatbox Rev4 and 5, the SGF Bridget and Faust, various Haute42 devices and the JFA Snackbox Micro.

You will need to print two of these to make a set.

It is recommended to flip one of them so you get a nice pair.

Please note that the set pictured here was done with a 0.2mm nozzle from Bambu but a 0.4mm nozzle works just fine.

I have tested this print on my Bambu X1C with the following changes to a stock configuration:
- 0.4mm nozzel
- 4 Wall loops
- 4 Bottom shell layers
- Honeycomb sparse infill pattern

This was printed in matte black PLA from Bambu.